Filter
Top Products
Changing a Tire When Trailer Towing
If you get a flat tire while towing a trailer, be sure
to secure the trailer and disconnect it from the
vehicle before changing the tire.
Trailer Wiring
Additional wire length has been provided for connecting
trailer wiring to your vehicle. A loop of five wires
is stored below the jack, which is located on the
driver’s side of the cargo area. The wires are fused
in both the underhood and instrument fuse block.
See Instrument Panel Fuse Block on page 5-95 and
Underhood Fuse Block on page 5-96.
The wires do not have a connector and should be
wired to the trailer by a qualified electrical technician.
The technician can use the following information
when connecting a trailer wiring harness to your vehicle.
• Yellow: Left Turn Signal
• Brown: Parking Lamps
• Light Blue: Stop Lamps
• Black: Ground Wire
• Dark Green: Right Turn Signal
When connecting a trailer harness, be sure you leave it
loose enough so the wiring does not bend or break,
but not so loose that it drags on the ground. Store
harness below jack in the cargo area when it is not in
use. Wrap the harness together and tie it neatly so it
will not be damaged.
4-62