Sanyo TH4242 Automobile Accessories User Manual


 
99
99
9
SC
76
S4359146
How to check overlapping of central address No.
(1) Press the and
ZONE
buttons at the same
time for more than 4 seconds.
and CODE No. C1 will flash.
(2) Select CODE. No. C3 by pressing ,
( ) button and press the button.
C3 changes from flashing to ON state and
will flash. Then auto. overlap checking will start .
(3) If C3 changes from ON to flashing and
stops flashing and disappears, there is no over-
lapping.
Then finally, complete the auto overlap checking
mode by pressing the button.
(4) If some of GROUP No., ZONE No. and UNIT No.
flash, you should try again the zone registration.
1 Select CODE No. C1 by pressing ,
( ) button and press the button.
2 Select the flashing GROUP No. with ZONE
and GROUP button.
Then press the button and reselect the
ZONE, GROUP and UNIT No.
3 Then finally, complete the auto. overlap
checking mode by pressing the button.
Fig. 9-11
2054_M_I
ZONE
ZONE
1
ZONE
SELECT
GROUP
9
2
3 4
6