Filter
Top Products
77
77
7
RC
(WL)
54
S4359146
<RCS-SH80UA. WL>
■ 4-Way Air Discharge Semi-concealed Type
(XH Type)
7-5. Indicator section Installation
● Remove the ceiling panel and indicator cover
and install the indicator section.
(1) Remove the ceiling panel.
(2) Remove the corner cover behind the mark sec-
tion. (3 screws)
(3) Remove the mark section inside the ceiling panel.
(2 screws)
(4) Install the indicator section in the location where
the mark section was attached. (2 screws)
(5) Form the wire to match the panel ribs as in the
Fig. 7-6.
(6) Install the corner cover. (Restrain the wire with
the corner cover.)
7-6. Operating Controller Installation
● Do not twist the operating
controller wires together
with the power supply
wires. Doing so can result
in malfunction.
● If noise is induced in the
unit power supply, take
appropriate measures, for
example installing a noise
filter.
Install the operating controller at the indoor unit intake
port section.
(1) Fasten the operating controller to the indoor unit
intake port section (electrical component box
opposite side) with the 2 accessory screws
(4 × L13/32 in.).
(2) Connect the operating controller 2 wires (WHT,
BLK) to the remote control wire (WHT) in the
electrical component box. (For details on the
wiring, see “7-9. Electrical wiring” P56.)
(3) Install the ceiling panel.
(4) Connect the indicator section and the operating
controller by 6P connector (white).
(5) Form the wires with vinyl clampers and fasten.
(6) Connect the ceiling panel wiring connector (2P,
3P) to the body connector in the electrical compo-
nent box.
(7) For details on test operation, see “Test Run”.
CAUTION
Ceiling panel
Air intake grille
Mark section
(indicator section)
0574_X_I
Fig. 7-5
Corner cover
3 screws
0517_X_I
Fig. 7-6
2 screws
0518_X_I
Indicator section
Wiring
Pass the wiring through under the shaft.
Fig. 7-7
1998_M_I
Electrical
component box
Operating
controller
Screws
11
11
1
X