Filter
Top Products
33
33
3
T
32
S4359146
(5) Before suspending the indoor unit, remove the 2
screws on the latch of the air-intake grilles, open
the grilles, and remove them by pushing the
claws of the hinges as shown in Fig. 3-59.
Then remove both side panels sliding them along
the unit toward the front after removing the two
screws which fix them. (Fig. 3-60)
(6) Preparation for suspending the indoor unit. The
suspension method varies depending on whether
the unit is next to the ceiling or not.
(Fig. 3-61 and 3-62)
(7) Suspend the indoor unit as follows.
(a) Mount a washer and two hexagonal nuts on
each suspension bolt as shown in Fig. 3-63.
Fig. 3-59
Slide toward
front side
Side panel
0972_T_
I
Fig. 3-60
unit
Suspension bolt
(field supply)
Ceiling surface
Washer (supplied)
Double nut
(field supply)
Fixture
0974_T_I
Fig. 3-61
unit
Suspension bolt
(field supply)
Washer (supplied)
Washer (field supply)
0976_T_I
Double nut
(field supply)
Fig. 3-62
Fig. 3-63
Slide
Hinge
Air-intake grille
Pull out the
Air-Intake grille
pushing claws
of the hinges
Screw
Latch
0973_T_
I
Ceiling
surface
1096_T_I
Approx.
1 inch
Suspension bolt
Washer
(supplied)
Nut
(field supply)