Filter
Top Products
8
Figure 8
10. Secure the deck lid in an open position
so it is a few inches above the tail light
assemblies – this is to protect all trunk
innards during hole drilling. (Figure 8)
11. Drill 1/8” pilot holes at the marked
locations in the deck lid, then open the
holes up to 5/16”.
12. Using the electric dremel with a
carbide tip, open up the stock holes on
the underside of the deck lid at the
locations indicated in Figure 9; Figure
10 is a close-up of Figure 9.
13. Open up both holes (driver side hole
shown close-up in Figure 11, passenger
side in Figure 12) to 5/8” wide by 7/8”
long, so that you can fit a 7/16” wobbly
socket in that holes. Make sure the
holes are oval in shape. Deburr the
holes.
Fi
g
ure 9
Figure 11
5/8”
7/8”
Driver side
Figure 10
Note fully
visible
Driver
side
hole;
expand
with
dremel