Filter
Top Products
10
Figure 17
Figure 16
Figure 18
Studs
Holes
in deck
lid
18. Before installing the wing, make sure
the number of studs in the wing
equals the number of holes drilled in
the deck lid. Do a test fit to make
sure all the holes line up. (Figure 16)
19. Apply adhesive promoter to the top
of the deck lid around both sets of
four holes. Follow the pattern in
Figure 17 (Figure 17 shows the four
holes on the passenger side of the
deck lid). Make sure the pattern of
adhesive promoter matches the
pattern of tape around the base of the
studs on the wing.
20. After verifying that the wing fits,
remove the backing from the tape on
underside of wing. (Figure 18)
21. Line up the studs in the wing with the
holes in the deck lid, and insert the
wing studs into the deck lid. (Figure
16)