Filter
Top Products
6
Order of Operations:
1. The two boxes in Figure 1 show the
location of the holes that will be drilled in
the deck lid to mount the rear wing.
2. Figure 2 shows the wing as it is shipped,
with the studs installed. The studs will go
into the holes you will drill in the deck lid.
3. Figure 3 is a close-up of the passenger side
of the wing. You will use the stud indicated
in Figure 3, as well as the one similarly
located on the driver side of the wing, as a
marker to properly place the holes in the
deck lid. The stud indicated in Figure 3
will go into hole “B” shown in the deck lid
in Figure 4. Figure 4 is a close-up of the
passenger side of the deck lid (Figure 1).
4. Lay down a blanket or plastic sheet in the
trunk to catch all the shavings from drilling
the deck lid.
Figure 4
A
B
C
D
Figure 3
Fi
g
ure 1
Figure 2
Driver side Passenger side
Front
of car
Wing leads
point to front
of car