Filter
Top Products
12
Fi
g
ure 24
Figure 23
Tighten
nut in
here
26. Place one washer (00-9004-
C11804*) and one hex nut (00-
9003-C11803*; use red Loctite)
over each (2 total) of the furthest
inboard studs (those that are not
easily visible) and tighten with an
angled ratcheting 7/16” wrench
(Figure 23 is a close-up of Figure
22; Figure 24 is a view of the inside
of the deck lid, and shows the nut
on the studs). Torque the nuts to 5
lb-ft.
27. Remove the rope from the deck lid.
28. Using the oval rubber plug (00-
9009-C11813*) cover each of the
two holes drilled out with the
electric dremel in step 12. (Figures
11,12)
29. Check to make sure you have
placed a nut on every stud on the
wing – four per side, or eight total
(four regular hex nuts and four
acorn hex nuts). Make sure all nuts
have been tightened securely and
torqued.
Figure 22