Filter
Top Products
11
Figure 19
Figure 20
SC Wing
Driver
side
Acorn
nuts
Deck lid
22. With the deck lid just partially open
(so the wing doesn’t fall out),
secure four outboard studs of wing
(two per side) with one washer (00-
9004-C11804*) and one acorn hex
nut (00-9003-C11802*; use red
Loctite). (Driver side nuts shown in
Figure 20). Torque the nuts to 5
lb-ft.
23. After the outboard studs of the
wing are secured, open the deck lid
all the way. Place a piece of ¼”
diameter rope inside the deck lid
through the hole drilled out with the
dremel, and pull the thread out of
the adjacent hole (Figure 21). This
is done to prevent hardware from
falling into the deck lid.
24. Place one washer (00-9004-
C11804*) and one hex nut (00-
9003-C11803*) over each of the
inboard studs (2 total) that are
accessed through the inboard holes
drilled out through the underside of
the deck lid in step 12. (Figures
11,12) Use Loctite on each nut.
25. Tighten the hex nuts using a 7/16”
socket and ¼” drive ratchet, tighten
hex nuts.
Figure 21
Insert rope
here
Thread
rope out
here