Filter
Top Products
7
Figure 5
1 ¼”
Figure 6
7/8”
1 ½”
7/8”
Front
of car
Front
of car
Figure 7
Studs
Holes in
deck lid
5. Mark each rearward, outboard hole
location for the wing studs with a
center punch. Mark the passenger
side hole (hole “B” in Figure 4) 1 ¼”
in from the passenger side outboard
edge of the deck lid, and 7/8” forward
from the outboard rear corner.
(Figure 5)
6. The driver side hole will be 1 ½” in
from the driver side outboard edge of
the deck lid, and 7/8” forward from
the rear outboard corner of the deck
lid. (Figure 6)
7. Drill 1/8” pilot holes at those two
rearward outboard hole locations
(steps 5,6), then open the holes up to
5/16”.
8. Place a dab of torque seal on the
bottom of each stud in the wing.
Using two people to hold the wing,
line up the outboard rearward holes in
the wing (Figure 3) with the marked
rearward outboard hole locations in
the deck lid (“B” in Figure 4; see also
Figures 5,6). The leads of the wing
go toward the front of the car; see the
photo on the cover page of this
manual, as well Figure 3, to properly
orient the wing.
9. Carefully lower the wing onto the
deck lid so the torque seal on the
bottom of the studs marks the hole
locations on the deck lid. Be very
careful when lifting the wing off the
deck lid so you don’t smear the
torque seal. (Figure 7)