Filter
Top Products
77Instruments and controls
Temperature control
The cabin is divided into two temperature
zones:
• The driver’s zone
• The passenger zone (front and rear
seats)
The desired temperature can be set
between 58 and 82°F (15 and 27°C). In
addition, there are also HI and LO settings
(see below). The HI and LO settings for the
passenger zone can only be selected if they
are also selected for the driver’s zone.
The displayed temperature is not the abso-
lute temperature but corresponds to the
comfort level normally experienced at that
temperature after allowance has been
made for the air flow, relative humidity, solar
radiation, etc., currently prevailing inside
the car.
• The most usual temperature setting is
64–76°F (18–24°C), depending on per-
sonal preference and what clothing is
worn.
• It is recommended that changes in the
temperature setting be made in steps of
2°F (1°C).
• Once the desired climate has been
achieved, the rear center vents can be
closed to prevent warm air being distrib-
uted at face height.
Settings when HI selected:
• Maximum heat
• Air distribution to windshield and floor
• Recirculation OFF (even if manually
selected before)
• Fan: high speed
• Settings shown on ACC display
Settings when LO selected:
• Maximum cooling (A/C compressor will
run even if ECON manually selected
before)
• Air distribution through panel vents
• Fan: maximum speed
• Recirculation ON
• Settings shown on ACC display
IB369
Air vent at rear side window