Polaris RANGER 4X4 Offroad Vehicle User Manual


 
64
MAINTENANCE AND LUBRICATION
Engine Oil
Oil Check (RANGER TM)
1. Position the vehicle on a level
surface.
2. Start the engine and let it idle for
20-30 seconds.
3. Stop the engine and remove the
seat as described on page 29.
Remove the service panel (1) by
pulling upward.
4. Remove the dipstick (2) and wipe
it dry with a clean cloth.
5. Replace the dipstick and seat it
completely.
6. Remove the dipstick and check to see
that the oil level is between the FULL
(3) and ADD (4) marks. Add oil
through the oil filler hole (5) as needed.
Do not overfill.
NOTE: A rising oil lev el between checks
in cool weather driving can indicate
moisture collecting in the oil reservoir.
If the oil level is over the full mark,
change the oil.
Oil and Filter Change (RANGER TM)
1. Position the vehicle on a level surface.
2. Run the engine two to three minutes until
warm, then s top the engine.
3. Clean the area around the drain plug (6) at the bottom of the
engine. The plug is accessible t hrough the access hole in the
bottom of the skid plate.
CAUTION
Hot oil can cause serious burns. Do not allow hot oil to come into
contact with skin.
4. Place a drain pan beneath t he engine and remove the drain plug.
Allow t he oil to drain completely.
1
2
4
5
6
3