Filter
Top Products
159
Chapter 6
Combining and Using Pioneer AV Equipment
■Setting the rear output and subwoofer controller
Pioneer AV Head Unit’s (AVH-P6400CD or AVH-P6400) rear output (rear speaker leads out-
put and RCA rear output) can be used for full-range speaker (REAR SPEAKER:FULL) or
subwoofer (REAR SPEAKER:SUBWOOFER) connection. If you switch rear output setting
to the REAR SPEAKER:SUBWOOFER, you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the Pioneer AV Head Unit (AVH-P6400CD or AVH-P6400) is set for rear fullrange
speaker connection (REAR SPEAKER:FULL).
When rear output are connected to full range speakers (when REAR SPEAKER:FULL is
selected), you can connect the RCA subwoofer output to a subwoofer. In this case, you can
select whether to use the subwoofer controller’s (low pass filter, phase) built-in S.W CON-
TROL:INTERNAL or the auxiliary S.W CONTROL:EXTERNAL.
➲ Even if you change this setting, there is no output unless you switch the non fading output
(refer to page 156) or subwoofer output (refer to page 155) in the audio menu on.
➲ If you change the subwoofer controller, subwoofer output and non fading output in the
audio menu return to the factory settings.
➲ Both rear speaker leads output and RCA rear output are switched simultaneously in this
setting mode.
1Press
5
or ∞ to select “REAR SPEAKER” from the INITIAL SETTINGS MENU, and
press A.MENU (AUDIO) button.
2 Change the rear output setting with
5
/∞.
Pressing 5/
∞
will switch between REAR SPEAKER:FULL (full-range speaker) and
REAR.SPEAKER:SUBWOOFER (subwoofer).
➲ When no subwoofer is connected to the rear output, select REAR SPEAKER:FULL.
➲ When a subwoofer is connected to the rear output, set for subwoofer REAR
SPEAKER:SUBWOOFER.
➲ When the rear output setting is REAR SPEAKER:SUBWOOFER, you cannot change the
subwoofer controller.
3 Change the subwoofer controller with 22
22
/ 33
33
.
Pressing
22
22
/ 33
33
will switch between S.W CONTROL:INTERNAL and S.W CON-
TROL:EXTERNAL.
■Switching the Telephone Muting/Attenuation
When a call is made or received using a cellular telephone connected to Pioneer AV Head
Unit (AVH-P6400CD or AVH-P6400), when there is a navigation guidance, you can select
between muting and attenuation when using the Handsfree Telephone Unit.
1Press
5
or ∞ to select “TEL/GUIDE MUTE/ATT” from the INITIAL SETTINGS MENU,
and press A.MENU (AUDIO) button.
2 Switch the telephone muting/attenuation with 22
22
/ 33
33
.
Pressing
22
22
/ 33
33
will switch between TELE/GUIDE:MUTE (muting), TELE/GUIDE:ATT
(attenuation) and TELE/GUIDE:NORMAL (normal).
MUTE : Volume is turned to 0.
ATT : Volume is set to 1/4.
NORMAL : Volume remains the same.