Filter
Top Products
MX80L Series Product Manual Chapter 3 - How to Use the MX80
Parker Hannifin Corporation
28
• Catalog specifications may deviate for positioners mounted to surfaces that do not meet the above
conditions.
• If the intended mounting surface cannot meet these specifications a separate rigid mounting plate
meeting these specifications should be used to mount to the main structure.
• If mounting conditions require that the table base is overhung, table specifications will not be met
over that portion of the table. Additionally, in X-Y Systems the overhung portion of the Y-axis may
not met specifications due to the additional error caused by deflection and non-support of the
base. Contact Daedal for guidelines on specifications of overhang applications
Load Mounting Requirements
Dowel holes are included in the carriage of the MX80L for repeatable mounting of loads/fixturing. When
bolting payload to carriage take precaution in using bolts M4 with 7mm of engagement as to not damage
the table.
Use appropriate length bolt.
The MX80L compact design requires proper sized bolts to be used when mounting payloads to the
carriage. Excessive length bolts can damage bearings or pin the table in position.
Daedal Division
Irwin
,
Penns
y
lvania