NorthStar Navigation M84 GPS Receiver User Manual


 
Northstar M121/M84 Installation and Operation Manual 99
20-11 Installation: Other NMEA instruments
NMEA is an industry standard for
interconnecting instruments. It is not as flexible
or as easy to install as NavBus.
The Instrument can:
Receive and display wind speed and
direction from an optional compatible wind
instrument.
Receive and display depth, paddlewheel
boat speed and water temperature from an
optional compatible instrument.
Receive data from an optional compatible
GPS or GPS/DGPS source.
Send GPS position and other navigation
data to an autopilot or other instrument.
An autopilot requires APB, APA and VTG
sentences (see section 19-12).
Setup and test
1 Put a blanking cap on any unused connector
on the back of the display unit. Ensure all
connectors are plugged in and the display
unit is in place.
2 If the display unit is bracket mounted, adjust
tilt and rotation for best viewing and hand
tighten the knob.
3 Insert any required C-MAP chart card (see
section 1-3).
4 Turn the instrument on (see section 2-2).
When the Instrument is turned on for the
first time, it displays an installation menu:
i Select the language to use.
ii Change the data if necessary (see section
2-1)
iii When the setup data is correct, press
ESC
.
This data can be changed later
(see section 19).
20-12 Installation: Setup and test
5 Enter setup data to set up the Instrument
to your requirements and to set up any
optional sensors or instruments (see section
19).
6 At the satellite window, check that it picks
up GPS satellites. Wait for the GPS receiver
to start up and the fix type to change from
‘Acquiring’ to ‘GPS fix’. This should take less
than two minutes (see section 8).
7 Go on a test run to check that the navigation
equipment works correctly, particularly
when a radio trans mitter or radar is used.
White NMEA out
Black NMEA ground
Power/data cable
Black
White
White NMEA in
(requires Special Fuel Cable)
For information on sending NMEA data to the
Instrument, see your Northstar dealer.
During setup to send NMEA data to other
instruments, set NMEA out to
and specify
the NMEA data to send (see section 19-12).