Filter
Top Products
M-Nav 650 || User Manual 57
14. Avoiding an Area / 15. Route Demonstrator
15 Route Demonstrator
The Route Demonstrator allows you to:
• Preview a route. During the preview, the
turns into a ‘S’ icon, reminding you that
the demonstration is a ‘S’imulation, not your actual progress on your journey.
• Plan and view a route without a GPS fix, such as when you are inside a building.
15.1 Select Departure Point
If you have a GPS fix, you do not need to select a departure point unless you want the demonstrated
route to start elsewhere.
1. From the Main Menu screen, select Map. The 2D Map screen will display.
2. Press
OK
to display the cross-hair on the 2D Map screen.
3. Position the intersection of the cross-hair using the
8-way toggle
. Where the cross-hair
intersect on a street, the street name will display at the bottom of the 2D Map screen.
4. Press
OK
. The Pop-up menu will display.
5. Select Set as Start Location, then press
OK
.The Pop-up menu will close.
15.2 Select Destination Point
Set a destination either by using the Destination screen (see Section 7) or by using the 2D Map screen
Pop-up menu by completing the following:
1. Press
OK
to display the cross-hair on the 2D Map screen.
2. Position the intersection of the cross-hair using the
8-way toggle
. Where the cross-hair
intersect, with a street, the street name will display at the bottom of the 2D Map screen.
3. Press
OK
. The Pop-up menu will display.
4. Select Navigate To, then press
OK
. The Pop-up menu will close. The 3D Map
screen will display the calculated route in Route Demonstrator mode.
• If you have selected the Route Demonstrator check box on the Routing
screen, the Route Demonstrator will demonstrate the route.
15.3 Activate Route Demonstrator
1. From the 2D Map screen, then press
OK
. The crosshair will display.
2. Press
OK
again. The Pop-up Menu will display.
3. Select Start Demonstrator.