Filter
Top Products
33
MN002000A © 2004 Navman NZ Ltd. All rights reserved. Proprietary information and specifications subject to change without notice.
Message ID: 1200
Rate: as required - maximum rate is 1 Hz
Message length: 27 words
Word No. Name Type Units Range Resolution
1-4 Message header
5 Header checksum
6 Sequence number (Note 1) I 0 to 32767
Initialisation Control (7.0-7.15)
7.0 Force time Bit
0 = normal
1 = forced
7.1 GPS time valid Bit 1 = valid
7.2 UTC time valid Bit 1 = valid
7.3 Lat/lon valid Bit 1 = valid
7.4 Altitude Valid Bit 1 = valid
7.5 Speed/course valid Bit 1 = valid
7.6 Magnetic course Bit 1 = magnetic
7.7 Climb rate valid Bit 1 = valid
7.8-7.15 Reserved
8 GPS week number UI weeks 0 to 32 767
9-10 GPS seconds into week UDI
s 0 to 604 799
11 UTC day UI days 1 to 31
12 UTC month UI months 1 to 12
13 UTC year UI years 1980 to 2079
14 UTC hours UI
h 0 to 23
15 UTC minutes UI min 0 to 59
16 UTC seconds UI
s 0 to 59
17–18 Latitude DI rad ±0 to
�/2 10
-9
19–20 Longitude DI rad ±0 to � 10
-9
21–22 Altitude DI m ±0 to 50 000 10
-2
23–24 Ground speed UI m/s 0 to 1000 10
-2
25 Course UI rad 0 to 2� 10
-3
26 Climb rate i m/s ±300 10
-2
27 Data checksum
Note 1: The sequence number is a count that indicates whether the data in a particular binary message has been updated or
changed since the last message input.
Table 3-23 Message 1200 (geodetic position and velocity initialisation)
3.5.2 Binary input message descriptions.
This section provides details for each of the input
binary messages.
3.5.2.1 Message 1200 (geodetic position and
velocity initialisation)
This message allows the user to initialise the
receiver with the specified geodetic position,
ground speed, course over ground, and climb
rate. The course may be either true or magnetic,
as indicated by the magnetic course field. The
GPS/UTC time represents the time at which the
solution was computed and, if present, will be
used to propagate the solution to the current time.
The contents of the ‘geodetic position and velocity
initialisation’ message are described in Table 3-23.