Filter
Top Products
Getting Started
Preparing your NAVIGON 5100 max for use
10 NAVIGON 5100 max User’s Guide December 2008
NAVIGON, INC. Version 2.1
Preparing your NAVIGON 5100 max for use
Charging the battery
• Connect the car charger cable to the navigation device and to the vehicle’s ciga-
rette lighter.
The LED of the NAVIGON 5100 max indicates the current battery charge. The
LED lights:
• No light, the battery has no charge.
• Orange during charging.
• Green when the battery is fully charged.
Power Interruptions
When power to the device is interrupted, the NAVIGON 5100 max can be configured
to put itself into Standby mode to save power. This occurs when the device is on and
is disconnected from a power source, such as:
• The vehicle cigarette lighter, or
• A wall outlet.
With this option, after a power interruption, the device waits 30 seconds, then puts
itself into Standby mode. When one of the above power interruptions occur, the follow-
ing message displays a 30 second countdown:
Tap:
• OK or wait until the 30 seconds countdown completes to allow the device to enter
Standby mode.
• Cancel to end the countdown and continue using the device.
Caution!
Please be sure to read, understand, and follow the safety information in
“Important safety information” on page 8.
Note: A 12 volt car charger cable is included with your device. An A/C wall charger is
also available as an optional accessory. Visit our web store www.navigonusa.com/store/
.
For more information on setting this option, see Automatic Standby in “General Set-
tings” on page 139.