Filter
Top Products
Issue: August 18 2004 Page 22
18.2 IN FAT MODE
"WRONG USB VERSION" DSP and USB software versions are incompatible
"CARD FULL" No more memory available on the card
"OPEN WRITE ERROR" Defective card or card error
"WRITE ERROR" Defective card or card error
"READ ERROR" Defective card or card error
"CARD TOO SLOW" Depending from the selected file format, some cards do not
accept a high recording bit rate
"DIRECTORY FULL" 999 takes (files) already recorded
"CARD NEARLY FULL" 60 seconds recording time left on the card
"KEYPAD LOCKED" The full keypad is locked
"AUTO POWER OFF" The machine will switch of in the next 15 seconds
"LOW BATTERY" The battery voltage has dropped too low
"NO AUTO POWER OFF" Auto power off has been disabled
"INVALID CARD" The card is not recognized by the machine
"NO CARD" No card inserted in the slot
"UNKNOWN FORMAT" The card is recognized but not the type of format
"DIR UNUSABLE" The “ARESP” folder cannot be created
Example: an ARESP file name was already present
"CARD READING..." Appears during the directory reading
"CARD BUSY..." Appears when the card is busy
Example: delete to end or renumbering
"USB MODE" The card is accessed via USB
“AUTO REC. LEVEL ERROR” The input gain level is not suitable to the record trigger level
19 SOFTWARE UPDATE
When opening the machine, a small black 6 pin connector becomes visible located just under the
flashcard. This connector is a RS232 connector. A special adapter “NP-PCA” is needed to connect the
RS232 from the machine to a PC or laptop.
When new software from NAGRA becomes available, it can be delivered by Email or it can be down-
loaded from the NAGRA web site. Thanks to a software called “PuserLoader” the machine can be
updated with the new software version. This takes about 2 to 3 minutes.