Filter
Top Products
Issue: August 18 2004 Page 19
14.5.9 OUTPUT MODE.
This sub-menu permits to turn on or off the sound to the output
connector in the case that a little speaker is used instead of a
headphone. “ALWAYS” means that the output sound is always present.
“ONLY IN PLAYBACK” means that the output sound is present only
during playback but not present in the record mode or EE mode.
14.5.10 OUTPUT LEVEL.
The “CURRENT LEVEL ” corresponds to the setting before entering the
sub-menu. To modify this level, press the “UP” or “DOWN” keys (9 or
11).
The “DEFAULT LEVEL ” is the level that has been saved in the memory.
To modify the “DEFAULT LEVEL ” to the value of the “CURRENT
LEVEL ”, press the “CENTER” Key (13). The default value will be
remembered even if the unit loses power.
14.5.11 SIDE RECORD KEY, ARES-P/RCX220.
This sub-menu permits to select different modes for the red record side
button. When selecting “RECORD/NEW TAKE”, the action on the side
button stays identical as for the keyboard record key. When selecting
“RECORD/STOP”, every time the red button is pressed once, the Ares-
P/RCX220 toggles between record and stop mode.
If “START/STOP” is selected, the record starts when the red
button is pressed and stops when the button is released.
This mode is also handy if a microphone with a start/stop button is used. Simultaneously
in this mode, during record, the keyboard record and stop key are disabled.
14.5.12 SIDE RECORD KEY, ARES-P II MARKERS.
This sub-menu also has the possibilty to set markers inside a file during
record or playback. If “RECORD/MARK” is selected, the first time the
button is pressed will put the Ares -P II in record. At each successive
press of the button, a marker will be recorded.
If ”MARK (REC/PLAY)” is selected, markers only can be added during
record or playback. If “UNASSIGNED” is selected, the function is not
used.
The Ares -P II also has the other possibilities as described in the previous paragraph (14.5.13).
14.6 AUTO RECORD, ARES-P II ONLY.
The “AUTO RECORD” menu permits to turn on or off the auto record mode. This mode of recording
permits to start a recording automatically depending on the settings of the different parameters
described below. Once the parameters set, put the machine in the record mode. The recording will
start once the requested level and length of any incoming sound is obtained.
OUTPUT LEVEL
CURRENT LEVEL = - 6 DB
DEFAULT LEVEL = - 9 DB
OUTPUT MODE
ALWAYS ON
ONLY IN PLAYBACK
ALWAYS ON
SIDE KEY
RECORD/NEW TAKE
RECORD/STOP
START/STOP
RECORD/STOP
SIDE KEY
RECORD/MARK
MARK (REC/PLAY)
START/STOP
MARK (REC/PLAY)
AUTO RECORD
MODE
TRIGGER LEVEL
TRIGGER DELAY
50 DB SPL
AUTO RECORD
TRIGGER LEVEL
TRIGGER DELAY
STOP DELAY
0.0 SEC.