Filter
Top Products
6A1 ENGINE (E-W) -
Rocker Arm and Camshaft <SOHC>
11A-9-2
REMOVAL SERVICE POINT
A
A
"
ROCKER ARMS AND ROCKER ARM SHAFTS
REMOVAL
(1) Before removing rocker arms and shafts assembly, install
the special tool as illustrated to prevent adjuster from
dropping.
INSTALLATION SERVICE POINTS
"
A
A
CAMSHAFT INSTALLATION
(1) Apply engine oil to journals an d cams of the camshaft
before installation.
Be sure to install the correct camshafts on the correct
bank.
Do not confuse the intake camshaft with the exhaust
one.
"
B
A
LASH ADJUSTER INSTALLATION
(1) Immerse the lash adjuster in clean diesel fuel.
(2) Using the special tool (air bleed wire), move the plunger
up and down 4 or 5 times while pushing down lightly
on the check ball in order to bleed out the air.
(3) Insert the lash adjuster to rocker arm, being careful not
to spill the diesel fuel. Then use the special tool to prevent
adjuster from falling while installing it.
"
C
A
ROCKER SHAFT SPRING / ROCKER ARMS AND
ROCKER ARM SHAFT INSTALLATION
(1) Temporarily tighten the rocker shaft with the bolt so that
all rocker arms on the inlet valve side do not push the
valves.
(2) Fit the rocker shaft spring from the above and position
it so that it is right angles to the plug guide.
NOTE
Install the rocker shaft spring before installing the exhaust
side rocker arms and rocker arm shaft.
PWEE9622
E
Feb. 1997Mitsubishi Motors Corporation
6AE0160
MD998443
6AE0180
For right bank
For left bank
6EN0421
Diesel
fuel
MD998442
6AE0161
Lash adjuster
MD998443
6AE0162