Mitsubishi 35C Automobile User Manual


 
ABS <2WD> -
Troubleshooting
35B-11
Code No.33 Stop lamp switch system (opencircuit orstop
lamp stays ON)
Probable cause
This code is output in the following cases.
D If the stop lamp switch is continuously on for 15 minutes or more even though
the ABS system is not operating.
D If there is an open circuit in the stop lamp switch input circuit harness.
D Malfunction of stop lamp switch
D Malfunction of wiring harness or connector
D Malfunction of hydraulic unit
NG
Repair
OK
NG
Repair
OK
NG
Repair
NG
Replace
NG
Replace the hydraulic
unit.
NG
Check the harness wire,
and repair if necessary.
D Between stop lamp
switch and ABS-ECU
NG
Repair
NG
Check the harness wire, and repair if necessary.
D Between fusible link No.1 and ABS-ECU
Check the trouble symp-
tom.
NG
Check the following
connectors:
A-04, C-75, C-65
Check the trouble symp-
tom.
OK
Check the following
connector:
A-04
YES
Measure at the ABS-ECU connector A-04.
D Disconnect the connector, and measure at the harness side
connector.
D Stop lamp switch: ON
D Voltage between 18 and body earth
OK:
Battery voltage
OK
Check the trouble symp-
tom.
OK
Check the following connectors:
C-12 <R.H. drive vehicles>, C-142, C-134, C-02, C-65, C-75, A-04
OK
Stop lamp switch check (Refer to GROUP 35A - Brake Pedal.)
Does the stop lamp turn on and off normally?
NO
Stop lamp switch installation check
ABS WARNING LAMP INSPECTION
35201200123
Check that the ABS warning lamp illuminates as
follows.
1. When the ignition key is turned to “ON”, the ABS warning
lamp illuminates for approximately 3 seconds and then
switches off.
2. When the ignition key is turned to “START”, the ABS
warning lamp remains illuminated.
3. When the ignition key is turned from “START” back to
“ON”, the ABS warning lamp illuminates for approximately
3 seconds and then switches off.
NOTE
The ABS warning lamp may remain on until the vehicle
reaches a speed of several km/h. This is limited to cases
where diagnosis code Nos.21 - 24 and 55 have been
recorded because of a previous problem occurring. In
this case, the ABS-ECU keeps the warning lamp
illuminated until the problem corresponding to that
diagnosis code can be detected.
4. If the illumination is other than the above, check the
diagnosis codes.
Not
illuminated
ABS
warning
lamp
ABS warning lamp
Illuminated
Approx. 3 s
Approx. 3 s
Ignition
switch
START
ON
ACC,
LOCK