Mitsubishi 35C Automobile User Manual


 
BASIC BRAKE SYSTEM -
Disc Brake
35A-23
A
A
"
PISTON BOOT/PISTON REMOVAL
Protect caliper body with cloth. Blow compressed air through
brake hose to remove piston boot and piston.
Caution
Blow compressed air gently.
A
B
"
PISTON SEAL REMOVAL
1. Remove piston seal with finger tip.
Caution
Do not use a flat-tipped screwdriver or other tool to
prevent damage to inner cylinder.
2. Clean piston surface and inner cylinder with
trichloroethylene, alcohol or specified brake fluid.
Specified brake fluid: DOT3 or DOT4
REASSEMBLY SERVICE POINT
"
A
A
LOCK PIN/GUIDE PIN INSTALLATION
Install the guide pin and lock pin as illustrated that each
head mark of the guide pin and the lock pin matches the
indication mark (“G” or “L”) located on the caliper body.
INSPECTION
35100630081
D Check cylinder for wear, damage or rust.
D Check piston surface for wear, damage or rust.
D Check caliper body or sleeve for wear.
D Check pad for damage or adhesion of grease, check
backing metal for damage.
Lock pin
Front
“L”
Guide pin
“G”