Filter
Top Products
Replacing bulbs
Example illustration: Bulb socket passenger side
:
Turn signal lamp
;
Backup lamp
i
The lamps on the driver’s side are
mirrored.
X
Depending on which bulb needs to be
replaced, turn the respective bulb socket
counterclockwise and remove it.
X
Gently press onto the bulb and turn it
clockwise out of its bulb socket.
X
Gently press the new bulb into its bulb
socket and turn it counterclockwise until it
engages.
X
Align the respective bulb socket and press
it into the tail lamp unit until it audibly
engages.
X
Reinstall the trim.
License plate lamps
X
Loosen screws : of lamp cover to be
removed.
X
Remove lamp cover ;.
X
Replace the bulb.
X
Reinstall lamp cover ;.
X
Retighten screws :.
Replacing wiper blades
Safety notes
G
Warning!
For safety reasons, switch off the wipers and
remove the SmartKey from the starter switch
(vehicles with KEYLESS-GO: Make sure the
vehicle’s on-board electronics have status 0)
before replacing a wiper blade. Otherwise, the
wiper motor could suddenly turn on and cause
injury.
G
Warning!
Wiper blades are components that are subject
to wear and tear. Replace the wiper blades
twice a year, preferably in the spring and fall.
Otherwise the windshield will not be wiped
properly. As a result, you may not be able to
observe surrounding traffic conditions and
could cause an accident.
!
To avoid damage to the hood, the wiper
arms should only be folded forward when
in the vertical position.
!
Never open the hood when a wiper arm is
folded forward.
Hold on to the wiper when folding a wiper
arm back. If released, the force of the
impact from the tensioning spring could
crack the windshield.
Do not allow a wiper arm to contact the
windshield glass without a wiper blade
inserted.
Mercedes-Benz recommends that you have
this work carried out at an authorized
Mercedes-Benz Center.
Replacing wiper blades
275
Practical hints
230_AKB; 6; 22, en-US
d2ureepe, Version: 2.11.8.1
2009-07-28T18:49:58+02:00 - Seite 275
Z