Filter
Top Products
X
Pull out oil dipstick :.
X
Wipe oil dipstick : clean.
X
Slowly insert oil dipstick : fully into the
dipstick guide tube.
X
Pull out oil dipstick : again after
approximately 3 seconds to obtain
accurate reading.
The oil level is correct when it is between
lower (min) mark = and upper (max)
mark ; of oil dipstick :.
i
SL 550 only:
The filling quantity between the upper and
lower marks on the oil dipstick is
approximately 2.1 US qt. (2.0 l).
i
SL 63 AMG only:
The filling quantity between the upper and
lower marks on the oil dipstick is
approximately 1.6 US qt. (1.5 l).
X
If necessary, add engine oil.
For more information on engine oil, see
“Fuels, coolants, lubricants etc.”
(Y page 303).
For information on messages in the
multifunction display concerning engine oil,
see the “Practical hints” section
(Y page 247).
Checking engine oil level with the
control system
On the SL 600 and SL 65 AMG you can check
the engine oil level with the control system.
i
In vehicles without engine oil measuring
system, the engine oil level is measured
with the oil dipstick (Y page 181).
X
Switch on the ignition.
The standard display appears in the
multifunction display (Y page 116).
X
Press button * or & on the
multifunction steering wheel repeatedly
until the following message appears in the
multifunction displays:
X
After about 3 seconds, the following
message appears in the left multifunction
display: Engine Oil Level Measuring
Now.
One of the following messages will
subsequently appear in the right
multifunction display:
R
Engine Oil Level
OK
R
Add 1.0 qt
to reach max.
oil level.
(Canada: 1.0 liter)
R
Add 1.5 qts
to reach max.
oil level.
(Canada: 1.5 liters)
R
Add 2.0 qts
to reach max.
oil level.
(Canada: 2.0 liters)
i
If you want to interrupt the checking
procedure, press button * or & on
the multifunction steering wheel.
X
If necessary, add engine oil.
For more information on engine oil, see
“Fuels, coolants, lubricants etc.”
(Y page 303).
Other display messages
If the ignition is not switched on, the following
message appears in the multifunction
display:
Turn ignition on
to measure
engine oil level.
X
Switch on the ignition.
182
Engine compartment
Operation
230_AKB; 6; 22, en-US
d2ureepe, Version: 2.11.8.1
2009-07-28T18:49:58+02:00 - Seite 182