Mercedes-Benz 2010 E-Class Sedan Automobile User Manual


 
X
Press button a to change the current
status.
Depending on the previous status, the
Daytime Running Lamps: mode will be
Enabled or Disabled.
With Daytime Running Lamps mode
enabled and the exterior lamp switch at
position $ or c, the daytime running
lamps are switched on when the engine is
running.
In low ambient light conditions the following
lamps will come on additionally:
R
Low-beam headlamps
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
For more information on the daytime running
lamp mode, see (Y page 98).
i
Make sure the exterior lamp switch is set
to M or c when you switch off the
daytime running lamps while driving at
night.
For safety reasons, resetting all the functions
of all submenus to the factory settings while
driving (Y page 139) will not deactivate the
daytime running lamp mode.
The following message appears in the
multifunction display:
Cannot Be Completely Reset to
Factory Settings while Driving..
Switching Adaptive Highbeam Assist on
or off
X
Press button = or ; to select the
Sett. menu.
X
Press button : or 9 to select the
Lights submenu.
X
Press button a.
X
Press button : or 9 to select the
Adaptive Highbeam Assist: function.
The current setting Enabled or Disabled
is shown.
X
Press button a to change the current
status.
Depending on the previous status, the
Adaptive Highbeam Assist: function
will be Enabled or Disabled.
For more information on the Adaptive
Highbeam Assist, see (Y page 100).
Switching locator lighting on or off
With the Locator Lighting: function
activated and the exterior lamp switch in
position c
R
the exterior lamps will come on during
darkness when the vehicle is unlocked with
the SmartKey.
The lamps will go out when the driver’s door
is opened.
If you do not open the driver’s door after
unlocking the vehicle with the SmartKey,
the lamps will go out automatically after
approximately 40 seconds.
R
the exterior lamps will remain on for
15 seconds during darkness after exiting
the vehicle and closing all doors.
142
Control system
Controls in detail
212_AKB; 2; 41, en-US
d2ureepe, Version: 2.11.8.1
2009-07-17T09:14:21+02:00 - Seite 142