Filter
Top Products
238
Controls in detail
Power windows
Fully opening the door windows
(Express-open)
̈ Press switch 1, 2, 3, or 4
(
୴ page 236) past the resistance point
and release.
The corresponding door window opens
completely.
Fully closing the door windows
(Express-close)
̈ Pull switch 1, 2, 3, or 4
(
୴ page 236) past the resistance point
and release.
The corresponding door window closes
completely.
If the upward movement of a door window
is blocked during the closing procedure,
the door window will stop and open slight-
ly.
̈ Remove the obstruction.
̈ Pull the respective power window
switch past the resistance point again
and release.
Stopping door windows during
Express-operation
̈ Press or pull respective power window
switch again.
Synchronizing the door windows
The door windows must be resynchronized
ț after the battery was disconnected
ț if the door windows cannot be fully
opened (Express-open) or closed
(Express-close)
̈ Close all doors.
̈ Switch on the ignition (୴ page 40).
̈ Pull and hold power window switch 1,
2, 3, or 4 (
୴ page 236).
Once a door window is closed com-
pletely, hold the respective switch for
approximately 3 seconds.
The door window is synchronized.
Warning! G
Driver’s door only:
If within 5 seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not function.
i
If the door window still does not close when
there is no obstruction, pull and hold the respec-
tive power window switch. The door window will
then close without the obstruction sensor
function.
i
Each door window must be resynchronized
separately.