Filter
Top Products
46
Getting started
Driving
1 Seat belt holder
2 Latch plate
3 Buckle
4 Release button
̈ With a smooth motion pull the belt
from seat belt holder 1.
̈ Place the shoulder portion of the belt
across the top of your shoulder and the
lap portion across your hips.
̈ Push latch plate 2 into buckle 3 until
it clicks.
̈ If necessary, tighten the lap portion to
a snug fit by pulling shoulder portion
up.
Proper use of seat belts
ț Do not twist the seat belt when
fastening.
ț Adjust seat belt so that the shoulder
portion is located as close as possible
to the middle of the shoulder (it should
not touch the neck). Never pass the
shoulder portion of the seat belt under
your arm.
ț Position the lap belt as low as possible
on your hips (over hip joint) and not
across the abdomen.
Warning! G
Never let more people ride in the vehicle
than there are seat belts available. Be sure
everyone riding in the vehicle is correctly
restrained with a separate seat belt. Never
use a seat belt for more than one person at
a time.
Warning! G
Never ride in a moving vehicle with the seat
backrest in an excessively reclined position
as this can be dangerous. You could slide
under the seat belt in a collision. If you slide
under it, the belt would apply force at the ab-
domen or neck. That could cause serious or
even fatal injuries. The seat backrest and
seat belt provide the best restraint when the
wearer is in a nearly upright position and the
belt is properly positioned on the body.
Warning! G
Read and observe the additional warning no-
tices printed in the “Safety and Security”
(
୴ page 64) and (୴ page 71).