Filter
Top Products
170
Controls in detail
Automatic transmission
Shifting procedure
The automatic transmission selects indi-
vidual gears automatically, depending on:
ț the gear selector lever drive position D
(
୴ page 171) with gear ranges
(
୴ page 174)
ț the selected shift program
(C/MAN/S)(
୴ page 175)
ț the position of the accelerator pedal
(
୴ page 173)
ț the vehicle speed
The current gear selector lever position
(
P
/
R
/
N
/
D
), the gear range (
1
/
2
/
3
/
4
) and
the shift program (
C
/
M
/
S
) are shown in the
standard display (
୴ page 117).
When the gear selector lever is in drive
position D, you can influence transmission
shifting by:
ț limiting the gear range
ț changing gears manually
Warning! G
It is dangerous to shift the gear selector
lever out of park position P or neutral N if
the engine speed is higher than idle speed.
If your foot is not firmly on the brake pedal,
the vehicle could accelerate quickly forward
or reverse. You could lose control of the
vehicle and hit someone or something. Only
shift into gear when the engine is idling
normally and when your right foot is firmly
on the brake pedal.
!
Allow engine to warm up under low load use.
Do not place full load on the engine until the
operating temperature has been reached
(
୴ page 307).
Shift into park position P or reverse gear R only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.