Filter
Top Products
250
Controls in detail
Power windows
Fully opening the door windows
(Express-open)
̈ Press switch 1, 2, 3, or 6
(
୴ page 248) past the resistance point
and release.
The corresponding door window opens
completely.
Fully closing the door windows
(Express-close)
̈ Pull switch 1, 2, 3, or 6
(
୴ page 248) past the resistance point
and release.
The corresponding door window closes
completely.
̈ Remove the obstruction.
̈ Pull the respective door window switch
past the resistance point again and
release.
Stopping door windows during
Express-operation
̈ Press or pull the respective door
window switch again.
Hinged quarter windows*
The switches for opening and closing the
hinged quarter windows are located on the
door control panel of the driver’s door
(
୴ page 35).
1 Hinged quarter windows: opening
2 Hinged quarter windows: closing
Opening
̈ Press and release switch 1.
To stop the hinged quarter window:
̈ Press and release switch 1 once
more.
Warning! G
Driver’s door only:
If within 5 seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not function.
i
If the upward movement of a door window is
blocked during the closing procedure, the door
window will stop and open slightly.
i
If the door window still does not close when
there is no obstruction, pull and hold the respec-
tive power window switch. The door window will
then close without the obstruction sensor
function.