Filter
Top Products
59
Getting started
Parking and locking
Turning off with the SmartKey
̈ Turn the SmartKey in the starter switch
(
୴ page 34) to position 0 and remove
it.
The immobilizer is activated.
Turning off the engine with
KEYLESS-GO*
̈ Place the gear selector lever in
position P.
̈ Press the KEYLESS-GO start/stop but-
ton (
୴ page 35) to shut off the engine.
With the driver’s door closed, the start-
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
(
୴ page 34).
Releasing seat belts
̈ Press the seat belt release button
(
୴ page 47).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
i
The SmartKey can only be removed
from the starter switch with the gear
selector lever in position P.
i
With the SmartKey removed and the
driver’s door open, a warning sounds if
the vehicle’s exterior lamps are not
switched off.
i
If you hear a warning signal, you have
either
ț forgotten to turn off the lights be-
fore opening the driver’s door
or
ț tried to turn off the engine while the
gear selector lever is not in P.
Turn off the lights or place the gear
selector lever in P.
!
Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.