Filter
Top Products
122
Controls in detail
Memory function
Prior to operating the vehicle, the driver
should check and adjust the seat height,
seat position fore and aft, and seat back-
rest angle if necessary, to ensure adequate
control, reach and comfort. The head re-
straint should also be adjusted for proper
height. See also the section on air bags
(
୴ page 63) for proper seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, operation
and comfort. Both the inside and outside
rear view mirrors should be adjusted for
adequate rear vision.
Fasten seat belts. Infants and small chil-
dren should be seated in a properly se-
cured restraint system that complies with
U.S. Federal Motor Vehicle Safety
Standards 213 and 225 and Canadian
Motor Vehicle Safety Standards 213 and
210.2.
With the memory function you can store up
to four different settings.
The following settings are stored when us-
ing the buttons on the driver’s door:
ț Driver’s seat and seat, backrest and
head restraint position
ț Settings for multicontour seat*
ț Steering wheel position
ț Exterior rear view mirror position
The following settings are stored when us-
ing the buttons on the passenger door:
ț Front passenger seat, backrest and
head restraint position
ț Settings for multicontour seat*
Warning! G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.