Filter
Top Products
297
Operation
Tires and wheels
Reactivating the tire inflation pressure
monitor
The tire inflation pressure monitor must be
reactivated in the following situations:
ț if you have changed the tire inflation
pressure
ț if you have replaced the wheels or tires
ț if you have installed new wheels or
tires
̈ Using the tire placard on the driver’s
door B-pillar or, if available, the inside
of the fuel filler flap, make sure the tire
inflation pressure of all four tires is cor-
rect.
̈ Press button è or ÿ on the mul-
tifunction steering wheel repeatedly
until the standard display menu
appears in the multifunction display
(
୴ page 137).
̈ Press button j or k repeatedly
until you see the current tire inflation
pressures for each tire appear in the
multifunction display or the following
message appears in the multifunction
display:
TIRE PRES. DISPLAY
APPEARS AFTER
DRIVING A FEW
MINUTES
̈ Press the reset button J on the in-
strument cluster (
୴ page 134).
The following message will appear in
the multifunction display:
MONITOR CURRENT
TIRE
PRESSURES?
̈ Press the æ button.
The following message will appear in
the multifunction display:
TIRE PRES. MONITOR
REACTIVATED
The tire inflation pressure monitor will
now monitor the tire inflation pressure
values of all four tires.
The following message will appear in
the multifunction display:
TIRE PRES. DISPLAY
APPEARS AFTER
DRIVING A FEW
MINUTES
This display appears until the individual
tire inflation pressure values are
matched with the tires. The individual
values are then displayed
(
୴ page 295).
i
If you are transporting a deflated tire in
the vehicle, do not activate the tire
inflation pressure monitor until
ț the deflated tire is no longer in the
vehicle
ț you have inflated the tire to the
correct tire inflation pressure
୴୴