Filter
Top Products
199
Controls in detail
Power windows
Fully closing the power windows
(Express-close)
̈ Press switch 1 to 2 at the
symbol j past the resistance point
and release.
The corresponding window closes com-
pletely.
Stopping power windows during
Express-operation
̈ Briefly press the respective window
switch again.
Synchronizing the power windows
The windows must be synchronized each
time
ț after the battery has been disconnect-
ed
ț if the windows cannot be fully opened
(Express-open) or closed
(Express-close)
Each window must be synchronized.
̈ Close all doors.
̈ Switch on the ignition (୴ page 34).
̈ Press and hold switches 1 to 4 at
the symbol j until the windows are
completely closed.
̈ Hold on to switches 1 to 4 for ap-
proximately 1 second.
The windows are synchronized.
Warning! G
Driver’s door only:
If within 5 seconds you again press the
switch past the resistance point and re-
lease, the automatic reversal will not func-
tion.
!
If the upward movement of the door
window is blocked during the closing
procedure, the door window will stop
and open slightly. Remove the obstruc-
tion, press the respective door window
switch at the symbol j again past
the resistance point and release. If the
door window still does not close when
there is no obstruction, press and hold
the respective door window switch at
the symbol j. The door window will
then close without the obstruction sen-
sor function.