Filter
Top Products
94
Controls in detail
Locking and unlocking
Unlocking and opening the trunk lid
A minimum height clearance of 5.71 ft
(1.74 m) is required to open the trunk lid.
The handle is located in the rear license
plate recess.
1 Handle
̈ Pull on handle 1.
The trunk opens.
or
̈ Press and hold button Š until the
trunk unlocks and begins to open.
The trunk can also be opened from its in-
side in an emergency, see “Trunk lid emer-
gency release” (
୴ page 103).
Closing the side windows and
sliding/pop-up roof*
̈ Press and hold lock button at door
(
୴ page 55) until the side windows and
the sliding/pop-up roof* are closed.
!
The trunk lid swings open upwards au-
tomatically. Always make sure there is
sufficient overhead clearance.
Vehicles with trunk lid opening/closing
system*: To stop the opening proce-
dure, press button Š. The Trunk lid
stops moving.
i
If the trunk lid does not open, it is still
locked separately (if applicable)
(
୴ page 104)
If the vehicle was previously centrally
locked, the trunk lid will lock automati-
cally when closed (
୴ page 97). The
turn signals will flash three times to
confirm locking.
Warning! G
When closing the windows and the
sliding/pop-up roof*, make sure there is no
danger of anyone being harmed by the clos-
ing procedure.
If potential danger exists, proceed as fol-
lows:
ț Release the lock button.
ț Pull on the door handle and hold firmly.
The side windows and the
sliding/pop-up roof* will open for about
two seconds if the door handle is held
but the door not opened.