Filter
Top Products
44
Getting started
Driving
Automatic transmission*
Gearshift pattern for automatic
transmission
P Park position with gear selector lever
lock
R Reverse gear
N Neutral
D Drive position
For more information, see “Automatic
transmission*” (
୴ page 142).
Starting
̈ Make sure the gear selector lever is set
to P.
̈ Do not depress the accelerator.
̈ Turn the SmartKey in the starter switch
to position 3 and hold until the engine
starts (
୴ page 31).
̈ Depress the brake pedal.
The gear selector lever lock is released.
For information on turning off the engine,
see “Turning off engine” (
୴ page 52).
Starting difficulties
If the engine does not start as described,
carry out the following steps:
̈ Turn SmartKey in starter to position 0
and repeat starting procedure
(
୴ page 43).
̈ Remember that extended starting at-
tempts can drain the battery.
̈ Get a jump start (୴ page 326).
If the engine does not start after several
starting attempts, there could be a mal-
function in the engine electronics or in the
fuel supply system.
̈ Notify an authorized Mercedes-Benz
Center.
i
You can also use the “touch-start”
function. Turn the SmartKey to
position 3 and release it again
immediately. The engine then starts
automatically.