Filter
Top Products
3. Disconnect the electrical connector
from the bulb by pressing the tab on
the connector with your finger and
pulling the conn ector downward.
4. Turn the socket and bulb assembly to
remove it. Carefully remove the bulb
from its socket in the reflector by
gently pulling it straight backward out
of the socket.
5. Install the new bulb in the reverse order
of removal.
NOTE
l
To replace the bulb, contact an Authorized
Mazda Dealer.
l
If the halogen bulb is accidentally touched,
it should be cleaned with rubbing alcohol
before being used.
l
Use the protective cover and carton for the
replacement bulb to dispose of the old bulb
promptly and out of the reach of children.
Front side marker lights
1. If you are changing the right side-
maker light, start the engine, turn the
steering wheel all the way to the right,
and turn off the engine. If you are
changing the left side-maker light, turn
the steering wheel to the left.
2. Make sure the ignition is switched off,
and the headlight switch is off.
3. Turn the screws and the center section
of the plastic retainers
counterclockwise and remove them,
then partially peel back the mudguard.
Removal
Installation
Maintenance and Care
Owner Maintenance
8-41
Mazda6_8AS3-EA-09E_Edition1 Page439
Wednesday, May 13 2009 2:26 PM
Form No.8AS3-EA-09E