Passive Car Jack:
It operate as below:
1. Turn the ignition switch to "ON", the system will arm.
2. Once the system is armed, if you are forced from the vehicle, the system will trigger when the
door is opened and closed while the ignition is "ON".
Trigger the Car Jack Mode:
3-timer circuits will function as follows:
First Timer:
A. 50 seconds after the system has been triggered, the siren will start chirping for 15 seconds.
B. During this 15 seconds period of chirping, you can push the valet switch once to turn off
the car-jacking feature.
C. If not, it will enter second timer car jacking mode.
Second Timer:
65 seconds after the system has been triggered. The siren starts alarming and the parking
light starts flashing.
Third Timer:
90 seconds after the system has been triggered:
A. The siren still alarming and the parking light flashing, and,
B. The starter disable will activate to prevent the vehicle from being re-started if turned Off.
C. It will remain active until the vehicle's battery power exhausted.
Override the System to Turn Off Car Jacking:
Turn the ignition switch form "OFF" to "ON", and within 10 seconds push valet switch, the siren
will stop and the system disarmed.
Note: If you use password pin code to double protect the vehicle security, you will need to use it
to completely disarm the system.
The alarm with a unique feature which will turn on your vehicle dome light as following:
1. Upon disarming, the interior lights will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.
Ignition Control Door Locks: (See Alarm Feature Programming Part 2-2)
If the vehicles door locks have been interfaced to the security system, the system will
automatically lock the vehicle's doors when the ignition is turned "ON" and /or unlock the
vehicle's doors when the ignition is turned "OFF".
Trunk Release (Factory Default Setting) / Timer Control Output: (See Alarm Feature Programming
Part 2-6)
Press and hold the ( ) button on the transmitter for two seconds to remote control the trunk
release or other electric devices.
Anti Car-Jacking
Dome Light Convenience Delay and Supervision
Ignition Control Door Locks
Trunk Release/Timer Control Output
9
M10UM 2/20/02 12:26 PM Page 9