Filter
Top Products
Melody sound from 2-way LCD Transmitter when remote start is activated.
Note: The remote start unit will not start the vehicle if any one of the
following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to "OFF" position.
(If installed)
4. The gear selector is in any gear other than "PARK" or "NEUTRAL".
When the engine is running (by remote start), if you want to stop it:
1. Press ( ) button on the transmitter.
2. Move the optional remote start enable toggle switch to the "OFF"
position. (If installed)
3. Press the brake pedal.
The vehicle will shut down and turn off the parking light to indicate
engine stopped.
To operate the vehicle while running on the remote start.
1. Insert the ignition key and turn it to "ON" (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the "ON" position, the engine will shut down.
11
Remote Start the Vehicle
To Turn Off the Remote Start
To Operate the Vehicle While Running on the Remote Start
This feature allows the vehicle to remain funning after the key has been removed from the ignition.
This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of
time, but would like to leave the motor running and the climate control on.
1. Before turning off the engine, press the ( ) button on the transmitter and the LED indicator
will flash 3 times to confirm enter.
2. Turn the ignition key to "OFF" position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapsed or shut down input is received.
Temporary Stop Feature
This unit can be programmed to start and run the engine every 3 or 24 hours. the engine will run
for the programmed run time and then shut down.
IMPORTANT: Timer Start should be used only in open area, never start and run the vehicle in on
enclosed space as a garage or carport.
3 hours timer start with temperature-control OFF: This feature is design for an extreme cold
climate usage. The system will auto start the vehicle every 3 hours, to prevent engine freezing and
hard to start. A MAXIMUM OF SIX CYCLES CAN OCCUR.
3 hours timer start with temperature-control: If you installed the optional Temperature Sensor
and programmed the temperature ON to operate. The system can be programmed to
automatically start the vehicle engine whenever the temperature inside the vehicle reaches or
drops below the preprogrammed temperature level. The system will monitor the air temperature
every 3 hours and will only start the engine during extreme cold temperatures. There are three
temperature level to choose from. (This feature is programmed "OFF" from the factory and must
be programmed ON to operate. (See Start Feature Programming Stage 1-7.)
Timer/Temperature Start
M10UM 2/20/02 12:26 PM Page 11