Filter
Top Products
When you want to check the system's present status thru the LCD screen, press the ( ) button
on the "Two Way LCD Screen Transmitter". With one melody sound, the system's status will be
shown on the LCD screen.
Note: Press "SET" for 2 seconds with 2 beeps confirmation to clear the trigger icons of LCD screen.
If you installed the optional Paging (Knock) Sensor, it is useful in the event that someone wants to
page the driver of the parked vehicle.
If someone tries to page you by tapping the paging (knock) sensor which is usually mounted on the
bottom part of front window, the paging melody sound continues sounding from your Remote LCD
Transmitter and "call" indication flashes on the LCD screen.
.
1. The function works only in arming status as well as press for 2 seconds.
It responds with
chirps of the vehicle's siren, melody sound and "call" indication flashes on the LCD screen to
confirm the function is on.
2. When tapping the paging (knock) sensor, one chirp sound shall be emitted from the vehicle.
3. Any time while the system arms again, the function will no longer be available.
This security system is equipped with circuitry that will allows the unit to remember its alarm state
if the power is lost and then reconnected.
Remote Start Operation
WARNINGS: As with any product that performs automatic functions, there are certain safety
precautions that you must practice and be aware of.
1. Keep the transmitter out of children's reach.
2. Do not leave anyone in the vehicle while running on remote control.
3. Alert servicing personnel that the vehicle can be started automatically.
4. Do not start the vehicle by remote while it's in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. Should the unit malfunction, disconnect the fuse until the problem is corrected.
7. The use and operation of this system is the sole responsibility of the operator.
8. Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.
When you want to start your vehicle:
1. Press ( ) button on the transmitter for 1 second.
2. The parking light will activate to indicate the remote start received the signal.
3. The engine will start approximately 5 seconds.
4.
Once the engine is running, after couple seconds the parking light will turn on again and climate
controls will activate and adjust the vehicle's interior temperature to your preset setting.
5. The vehicle will run for 5 to 30 minute cycle and automatically shut down.
10
System's Status Check
Driver Paging (Optional)
Power Memory
To Remote Start Operation
M10UM 2/20/02 12:26 PM Page 10