Filter
Top Products
24 hours timer start: This feature is design for a battery charge usage. When the car owner has a
long vacation, he can use this feature to auto start the vehicle and charge the battery every day, to
prevent a low battery.
Enter:
1. Press the ( ) button to remote start the vehicle. As soon as the vehicle is running and the
parking light have turned on or flashing.
2. Immediately depress the ( ) button once, within 2 seconds.
3a. 3 hour auto start: Rapidly depress the ( ) button once. The parking light will slash (3) times.
The siren or horn chips (3) times. The vehicle is now programmed to
start every (3) hours.
3b.
24 hours auto start: Rapidly press and hold the ( ) button once. The
parking lights will flash (12) times. The siren or horn chirps (12) times.
The vehicle is now programmed to start ever (24) hours.
4. Press the brake pedal to stop the vehicle running.
Exit the Timer Start: Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. turn the ignition "ON". the LED and parking light will flash (4) times. The horn chirps (4) times.
or
1. Press the ( ) button to remote start the vehicle. As soon as the vehicle is running and the
parking light have turned on or flashing.
2. Immediately depress the ( ) button then press and hold the ( ) button for 2 seconds. The
parking lights will flash (4) times. The siren or horn chirps (4) times. The vehicle is no longer
programmed to start automatically.
Timer/Temperature Start
Temperature Check (Optional)
If you installed the optional temperature sensor, you can monitor, thru the
LCD screen, the present indoor temperature of the passenger
compartment before cooling or heating your vehicle.
Press the ( ) and ( ) button at the same time on the Two Way LCD
Screen Transmitter", the in-door temperature and system's status will be
shown on the LCD screen.
Shut-Down Input for Remote Starter
If any of the following conditions exist while the system is operating, the engine will not start or will
shut down immediately
1. The hood is opened.
2. The brake pedal is pressed.
3. Engine is over-revved. (Tachometer Checking Type Only)
4. The pre-programmed run time is 5/10/20/30 minutes has elapsed.
5. Transmitter button ( ) is pressed.
6. Move the optional remote star enable toggle switch to OFF position (if installed).
7. The vehicle refused to start running after (3) unsuccessful attempts.
Disabling the Remote Start System (If Installed)
This feature allows your system's remote start unit to be temporarily disabled to prevent the vehicle
from being remote started accidentally. This feature is useful if the vehicle is being serviced or
stored in an enclosed area. To disable the remote start, move the optional remote start toggle
switch to the OFF position.
M10UM
1-15-02 Rev. A
M10UM 2/20/02 12:26 PM Page 12