Filter
Top Products
13
REMOTE START OPERATION
1. Press the button twice on the transmitter.
2. The parking lights will be activated, indicating the remote start received the signal.
3. The engine will start approximately 5 seconds.
4. Once the engine is running, after a couple seconds the parking light will turn on again and
climate controls will activate and adjust the vehicles interior temperature to your preset setting.
5. The vehicle will run for a 5 to 30 minute cycle and automatically shut down.
Note: The Remote Start Unit will not start the vehicle if any one of the following conditions exist:
A. The hood is opened.
B. The brake pedal is pressed.
C. Move the optional remote start enable switch to “OFF” position (If installed).
D. The gear selector is in any gear other then “PARK” or “NEUTRAL”.
Actions of the 2-Way LED Remote Control Transceiver
Press the button twice on the transmitter to start the vehicle (factory default setting). If your
transmitter has been programmed to the “Safe Start” feature, press the and buttons at the
same time to remotely start the vehicle.
LED Melody Sound
Activate Remote Start LED Fast Flash for 2 Seconds One “Activate” Melody Sound
Engine Running LED Fast Flash for 60 Seconds “Beep Sound” for 5 Seconds
Stop The Remote Start One “Stop” Melody Sound
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the “ON” position, the engine will shut
down.
This feature allows the vehicle to remain running after the key has been removed from the
ignition. It is useful when you wish to exit and lock the vehicle for short periods of time, but
would like to leave the motor running and the climate control on.
1. Before turning off the engine, press the button twice on the transmitter and the LED
indicator will flash 3 times to confirm.
2. Turn the ignition key to the “OFF” position (the engine will stay running).
3. The engine will run until the pre-programmed time elapsed or shutdown input is received.
To Remote Start the Vehicle
Safe Start
(Also See Installation Manual)
To Operate the Vehicle While Running on the Remote Start
Temporary Stop Feature