Filter
Top Products
123
3. To return to the previous page, press
EXIT|EXIT.
To turn off displayed data:
1. From the Map or Sonar page, press MENU|↓ to OVERLAY DATA|ENT.
2. Press ↓ or ↑ to select Data Type|
ENT. The selected data type disap-
pears from the top of the list and reverts to its previous, unchecked po-
sition. (If you wish, you may now use ↓ or ↑ to select other Data Types
to turn off.)
3. To return to the previous page, press
EXIT|EXIT.
To change displayed data font size:
1. From the Map or Sonar page, press MENU|↓ to OVERLAY DATA|ENT.
2. Press ↓ or ↑ to select Data Type|press → or ← to Data
Size|
EXIT|EXIT. The selected data type will be displayed in the new
size. (To change the font size for more than one Data Type at the same
time, just follow the above steps, but make all the needed changes be-
fore you press Exit to clear the menu.)
Tip:
If you wish, you can change the font size when you select a data
type for the first time:
1. From the Map or Sonar page, press
MENU|↓ to OVERLAY
DATA|ENT.
2. Press ↓ or ↑ to select Data Type|press → or ← to select Data
Size|
ENT.
The data will be shown in the new font size. To return to the previ-
ous page, press
EXIT|EXIT.
Pop-up Help
Help is available for virtually all of the menu labels on this unit. By
highlighting a menu item and leaving it highlighted for a few seconds, a
"pop-up" message appears that describes the function of the menu item.
This feature is on by default.
To set up Popup Help: Press
MENU|MENU|↓ to SYSTEM SETUP|ENT|↓
to
POPUP HELP. With the option highlighted, press ENT to check it (turn
on) and uncheck it (turn off.) After the option is set, press
EXIT|EXIT to
return to the page display.