Filter
Top Products
36
Memory card compartment with a 16 MB MMC card installed.
To remove an MMC
1. Open the card compartment door by unscrewing the thumb screw.
The screw should only be finger tight. If it was over-tightened, use a
thumbnail, a coin or a screwdriver to open the door.
2. Use a thumbnail or fingernail to grab the groove in the bottom of the
MMC. See the figure above for the groove location.
3. Drag the MMC from the slot.
To add an MMC or SDC
1. Open the card compartment door.
2. Grasp the bottom of the MMC and push the top of the card into the
slot. Once the card is started, use your fingernails to slide it the rest of
the way to the left, until it is firmly seated in the slot.
3. Close the compartment door and fasten the thumb screw finger tight.
Other Accessories
Screen Cleaning Kit
Your unit's display screen is equipped with a special anti-glare filter
that improves readability in a wide range of lighting conditions. A bot-
tle of filter cleaning fluid is included with your unit. Additional bottles
of cleaner may be purchased from your dealer or LEI Extras, the acces-
sory source for Lowrance equipment. Accessory ordering information is
on the inside back cover of this manual.
WARNING:
Improperly cleaning your unit's screen can result in
damage to the anti-glare filter. This type of damage is
not covered by the warranty. To protect the screen and
Insert card face up,
this way
Thumb
screw
MMC groove for card removal