Filter
Top Products
35
Once a location is determined, use the bracket as a template and mark
the mounting holes and the hole for the cables. Drill a 1-inch (25.4 mm)
hole in the dash for the power, transducer and antenna cables. Screw
the bracket to the mounting surface.
To pass all connectors through the 1" hole, first pass the transducer
connector up through the hole from under the dash, followed by any
accessory cables. Next, pass the power cable's bare-wire end down
though the hole from the top.
If you wish, you can fill in the hole around the cables with a good ma-
rine caulking compound. Be sure to leave enough slack in the cables to
allow tilting the unit.
Attach the unit to the gimbal bracket using the supplied gimbal knobs
and washers, attach the cables and the unit is ready to use.
MMC or SDC Memory Card Installation
Your unit uses MultiMedia Cards to store information, such as sonar
logs, custom maps, waypoints, trails and other GPS data. The unit can
also use Secure Digital Cards (SD card or SDC) to store data. The unit
can use up to two cards at the same time; an MMC and an SDC can be
used together at the same time.
NOTE:
Throughout this manual, we will use the term MMC, but just re-
member that your unit can use an MMC or SDC to store data.
Both of these solid-state flash memory devices are about the size of a
postage stamp. An SD card is slightly thicker than an MMC. As this
manual went to press, MMCs were available in storage capacities of 8
MB, 16 MB, 32 MB and 64 MB. SD cards were available in capacities of
8 MB, 16 MB, 32 MB, 64 MB, 128 MB and 256 MB.
Additional MMC cards are available from LEI Extras; see ordering in-
formation inside the back cover of this manual. MMCs and SD cards
are also available at many camera and consumer electronics stores.
The two MMC slots are located in compartments on the front of the
case. The water-proof compartment doors are located at the lower right
corner. The following figure shows a close-up of one compartment with
the door opened.