Filter
Top Products
56 DNX5360/DNX5360M/DDX5036/DDX5036M
Audio Control
Audio Control Menu
Displays the Audio Control menu to set the sound
effect function of this unit.
Display the Source Select Screen1
SRC
Display the Audio Control menu2
In this manual, the above selection is indicated
as:
Touch [ ]
>
[ ].
Select the Audio Control item3
Item Page
[Audio Control] 56
[Equalizer] 57
[Tone] 57
[Zone Control] 58
Audio Control
You can adjust the front/rear and right/left audio
balance.
Display the Audio Control screen1
Touch [
]
>
[ ]
>
[Audio Control]. (page 56)
Set each item2
1
1
1
1 Adjusts the front/back and left/right balance
of the volume by touching the Adjust screen.
[2], [3] Adjusts the right and left volume
balance.
[5], [∞] Adjusts the front and rear volume
balance.
[VOL.Offset] Finely adjust the volume of the
current source to minimize the difference in
volume between different sources.
⁄
If you have increased the volume first, then reduced •
the volume using the "VOL. Offset", the sound
generated if you suddenly switch to another source
may be extremely loud.
[Subwoofer Level] Adjusts the subwoofer
volume.
The setting is available when subwoofer is set
to "ON". See <Speaker Setup> (page 72).
[Loudness] Turns the loudness control
function On or Off.
If turned "ON", high and low tones are
automatically enhanced during low volume.
Settable only when zone function is set to Off.
See <Zone Control> (page 58).
[Stream Information] Displays the present
source information.
The stream (Dolby Digital, dts, Linear PCM,
MPEG, MP3, WMA or AAC) is displayed.