Filter
Top Products
1. To throttle bodies connector (Brown).
2. Intake Air Temperature Sensor (Black)
3. Frame Ground
4. Regulator
5. Starter Relay
6. To front sub harness connector (26031-0307 or 26031-0308).
7. Camshaft Position Sensor (Gray)
8. Ignition Coils (Gray)
9. Camshaft Position Sensor
10. Connect to the ignition coil (with tape from #1 to #4)
11. Auto Shifter (Blue)
12. White Connector (do not use)
13. Fuel Pump (Black)
Remove the original main harness from the frame.
Install the kit main harness (26031-0425, 0426) as shown in the illustration.
Use the original part for the [8] battery ground cable.
Connect the [9] camshaft position sensor connector to the camshaft position sensor at
the cylinder head front side.
When using the recommended auto shifter to connect the [11] auto shifter connector.
NOTE
When using the kit tachometer, always connect the water temperature sensor connector
at the cylinder head rear side.
For recommended auto shifter, refer to the Kawasaki FI Calibration Tool Instruction
Manual of another sheet.
49