Filter
Top Products
The following abbreviations are used to represent values for Control Module Pin-Out data
I Input PG Power Ground C CAN Network D Serial and Encoded Data
O Output SS Sensor / Signal Supply V S SCP Network V Voltage (DC)
B+ Battery Voltage SG Sensor / Signal Ground D2 D2B Network PWM Pulse Width Modulated
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all components
connected and fitted.
Refer to the front of this book for detailed information and illustrations regarding the location and identification of harnesses, relays, fuses, grounds, control
modules and control module pins.
DATE OF ISSUE: June 2002
Fig. 05.4
COMPONENTS
Component Connector(s) Connector Description Location
ADAPTIVE DAMPING CONTROL MODULE CA11 16-WAY / BLUE LUGGAGE COMPARTMENT, REAR
CA12 16-WAY / GREY
DAMPER SOLENOID – LH FRONT FH117 2-WAY BLACK TOP OF LH FRONT DAMPER
DAMPER SOLENOID – LH REAR CA140 2-WAY BLACK TOP OF LH REAR DAMPER
DAMPER SOLENOID – RH FRONT FH118 2-WAY BLACK TOP OF RH FRONT DAMPER
DAMPER SOLENOID – RH REAR CA111 2-WAY BLACK TOP OF RH REAR DAMPER
DYNAMIC STABILITY CONTROL CONTROL MODULE FH103 47-WAY / BLACK ENGINE COMPARTMENT, RH FRONT
INSTRUMENT CLUSTER FC14 22-WAY / GREY INSTRUMENT PANEL
FC15 20-WAY / BLACK
FC63 22-WAY / BLACK
LATERAL ACCELEROMETER FH70 3-WAY / BLACK REARWARD OF FRONT BUMPER, LH SIDE
REAR ELECTRONIC CONTROL MODULE CA63 17-WAY / BLACK LUGGAGE COMPARTMENT, RH REAR
CA100 12-WAY / BLACK
CA101 20-WAY / BLACK
CA102 22-WAY / BLACK
CA103 26-WAY / NATURAL
VERTICAL ACCELEROMETER – FRONT FH63 3-WAY / BLACK REARWARD OF FRONT BUMPER, LH SIDE
VERTICAL ACCELEROMETER – REAR CA17 3-WAY / BLACK LUGGAGE COMPARTMENT, RH REAR
HARNESS IN-LINE CONNECTORS
Connector Connector Description / Location Location
CA3A/B 14-WAY / GREY / CABIN HARNESS BRIDGE LUGGAGE COMPARTMENT, LH REAR
CA4A/B 10-WAY / GREY / CABIN HARNESS BRIDGE LUGGAGE COMPARTMENT, LH REAR
FH2 16-WAY / GREY / CABIN HARNESS TO FRONT HARNESS RH ‘A’ POST, LOWER
FH6 16-WAY GREEN / CABIN HARNESS TO FRONT HARNESS LH ‘A’ POST, ADJACENT TO GECM
GROUNDS
Ground Location
CA158 LUGGAGE COMPARTMENT, LH SIDE REAR CORNER
FOR CONTROL MODULE PIN-OUT INFORMATION, UNFOLD PAGE TO LEFT.
CONTROL MODULE PIN-OUT INFORMATION
Adaptive Damping Control Module
Pin Description and Characteristic
O CA11-1 RH REAR DAMPER SOLENOID DRIVE: PWM +
O CA11-2 RH REAR DAMPER SOLENOID DRIVE: PWM -
O CA11-3 LH REAR DAMPER SOLENOID DRIVE: PWM +
O CA11-4 LH REAR DAMPER SOLENOID DRIVE: PWM -
O CA11-5 LH FRONT DAMPER SOLENOID DRIVE: PWM -
O CA11-6 LH FRONT DAMPER SOLENOID DRIVE: PWM +
O CA11-7 RH FRONT DAMPER SOLENOID DRIVE: PWM -
O CA11-8 RH FRONT DAMPER SOLENOID DRIVE: PWM +
SG CA11-9 SIGNAL GROUND (INTERNALLY CONNECTED TO PIN 10): GROUND
PG CA11-10 POWER GROUND: GROUND
B+ CA11-12 IGNITION SWITCHED POWER SUPPLY (II): B+
SCA11-13 SCP -
SCA11-14 SCP +
B+ CA11-16 BATTERY POWER SUPPLY: B+
SS CA12-9 SENSOR SIGNAL SUPPLY VOLTAGE: NOMINAL 5 V
ICA12-10 REAR VERTICAL ACCELEROMETER SIGNAL: SENSOR SIGNAL
ICA12-11 LATERAL ACCELEROMETER SIGNAL: SENSOR SIGNAL
ICA12-12 FRONT VERTICAL ACCELEROMETER SIGNAL: SENSOR SIGNAL
Dynamic Stability Control Control Module
Pin Description and Characteristic
CFH103-11 CAN +
CFH103-12 CAN +
CFH103-14 CAN -
CFH103-15 CAN -
Instrument Cluster
Pin Description and Characteristic
C FC15-8 CAN +
C FC15-9 CAN –
SFC15-10 SCP –
CFC15-18 CAN +
CFC15-19 CAN –
SFC15-20 SCP +
Rear Electronic Control Module
Pin Description and Characteristic
SCA102-1 SCP +
SCA102-2 SCP -
NOTE: Refer to the Appendix at the rear of this book for Network Messages.