Filter
Top Products
The following abbreviations are used to represent values for Control Module Pin-Out data
I Input PG Power Ground C CAN Network D Serial and Encoded Data
O Output SS Sensor / Signal Supply V S SCP Network V Voltage (DC)
B+ Battery Voltage SG Sensor / Signal Ground D2 D2B Network PWM Pulse Width Modulated
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all components
connected and fitted.
Refer to the front of this book for detailed information and illustrations regarding the location and identification of harnesses, relays, fuses, grounds, control
modules and control module pins.
DATE OF ISSUE: June 2002
Fig. 04.1
COMPONENTS
Component Connector(s) Connector Description Location
CLUTCH CANCEL SWITCH CA285 (LHD) 2-WAY / BLACK TOP OF CLUTCH PEDAL (TOP SWITCH)
CA291 (RHD) 5-WAY / BLACK
CLUTCH PEDAL POSITION SENSOR CA287 6-WAY / BLACK TOP OF CLUTCH PEDAL
CLUTCH PEDAL SAFETY SWITCH CA286 2-WAY / BLACK TOP OF CLUTCH PEDAL (BOTTOM SWITCH)
ENGINE CONTROL MODULE PI1 134-WAY / BLACK FRONT BULKHEAD, PASSENGER SIDE
IGNITION SWITCH FC18 7-WAY / BLACK STEERING COLUMN COWLING
J GATE MODULE CA245 16-WAY / BLACK J GATE ASSEMBLY
NEUTRAL SWITCH GB4 2-WAY / BLACK TRANSMISSION, LH REAR
PARKING BRAKE CONTROL MODULE CA241 4-WAY / BLACK LUGGAGE COMPARTMENT, RH REAR
CA242 12-WAY / BLACK
REVERSE SWITCH GB5 2-WAY / BLACK TRANSMISSION, LH REAR
TRANSMISSION CAPACITOR (V6) GB17 2-WAY / BLACK ENGINE COMPARTMENT, BULKHEAD
TRANSMISSION CAPACITOR (V8) PI59 2-WAY / BLACK ENGINE COMPARTMENT, BULKHEAD
TRANSMISSION CONTROL MODULE GB2 16-WAY / BLACK TRANSMISSION CONTROL VALVE ASSEMBLY
HARNESS IN-LINE CONNECTORS
Connector Connector Description / Location Location
FC26 16-WAY / BLUE / CABIN HARNESS TO FASCIA HARNESS BEHIND INSTRUMENT PANEL, DRIVER SIDE
FH1 20-WAY / BLACK / CABIN HARNESS TO FRONT HARNESS RH ‘A’ POST, LOWER
FH3 16-WAY / BLUE / CABIN HARNESS TO FRONT HARNESS LH ‘A’ POST
GB1 16-WAY / GREY / ENGINE HARNESS TO TRANSMISSION HARNESS ADJACENT TO TRANSMISSION BELL HOUSING
PI41 42-WAY / BLACK / ENGINE HARNESS TO VEHICLE HARNESSES ENGINE COMPARTMENT, BULKHEAD, PASSENGER SIDE
PI42 8-WAY / BLACK / ENGINE HARNESS TO FRONT HARNESS ENGINE COMPARTMENT, BULKHEAD, PASSENGER SIDE
GROUNDS
Ground Location
CA141 UNDER LH FRONT SEAT
PI40 (LHD) ENGINE COMPARTMENT, BEHIND RH WHEEL ARCH LINER
PI40 (RHD) ENGINE COMPARTMENT, BEHIND LH WHEEL ARCH LINER
FOR CONTROL MODULE PIN-OUT INFORMATION, UNFOLD PAGE TO LEFT.
CONTROL MODULE PIN-OUT INFORMATION
Parking Brake Control Module
Pin Description and Characteristic
ICA242-3 IN-GEAR SWITCH (NORMALLY OPEN): OPEN CIRCUIT / GROUND
SS CA242-8 SIGNAL SUPPLY VOLTAGE: NOMINAL 5 V
SG CA242-9 SIGNAL GROUND: GROUND
I CA242-11 CLUTCH PEDAL POSITION SENSOR FEEDBACK SIGNAL: VARIABLE VOLTAGE
Engine Control Module
Pin Description and Characteristic
IPI1-31 AUTOMATIC – PARK / NEUTRAL SIGNAL: B+ WHEN ACTIVATED
MANUAL, ROW – PARK / NEUTRAL SIGNAL: B+ WHEN IGNITION CRANK (III)
MANUAL, NAS – CLUTCH PEDAL SAFETY SWITCH (PARK / NEUTRAL SIGNAL): B+ WHEN ACTIVATED
IPI1-33 CLUTCH CANCEL SWITCH: NORMALLY CLOSED / GROUND WHEN ACTIVATED
Transmission Control Module
Pin Description and Characteristic
C GB2-2 CAN -
C GB2-6 CAN +
B+ GB2-9 IGNITION SWITCHED POWER SUPPLY: B+
O GB2-10 PARK / NEUTRAL SIGNAL: GROUND WHEN ACTIVATED
PG GB2-13 POWER GROUND: GROUND
B+ GB2-14 BATTERY POWER SUPPLY: B+
PG GB2-16 POWER GROUND: GROUND
NOTE: Refer to the Appendix at the rear of this book for Network Messages.