Filter
Top Products
4.4 The Powercard will mount to the underside of
the large metal plate. Find a location where the
Powercard can be without hitting the ECU. Make
sure both the metal plate and the back of the
Powercard are clean. Peal one half of the includ-
ed Velcro and attach it to the Powercard. Peal
the other half and attach it to the location picked.
4.5 Reinstall the plate, the carpet, the kick panel
trim and the two screws from door sill trim.
5.0 SUPERCHARGER PREPARATION
5.1 Working on a table, set the supercharger unit
in a position easy to work with. Be very careful
not to bump the supercharger pulley in any way
as it can easily damage the front bearing. Check
outlet manifold for debris and clean it out if nec-
essary. Install the outlet manifold as shown in fig-
ure 5.1. Get your Mazda throttle body with the
ICS blanking plate as installed in step #2.7 and
mount it to the supercharger using a thin film of
the sealant provided and the four bolts (8mm x
40) supplied in the kit.
5.2 Locate your throttle cable bracket that is bolt-
ed to your standard intake manifold and remove
the throttle cable by loosening the pinch nuts
surrounding the cable end on either side of the
bracket. Once the nuts are loose, you can pull
the cable out of the bracket - the grommet will
deform and let you do this. Remove the throttle
cable bracket by removing the two 10mm head-
ed
bolts. Unclip the throttle cable from the firewall
anchors. Begin rerouting the throttle cable by
looping the end behind the brake master cylinder
and laying it along the driver’s side fender well.
5.3 Locate the black plastic Roto-mold inlet elbow
from your kit. Check elbow for debris and clean it
out if necessary. You will be placing the assembly
into the position shown prior to installing the
supercharger. Make sure to install the 2.5” to
2.75” reducer hose to the airflow meter end of
this plastic elbow prior to setting it in place. This
will greatly assist in airflow meter installation.
Also, install the 2.5” diameter hump hose to the
throttle body end of this plastic elbow. Use the
Supercharger Installation Instructions
999-156 -8- Revised 1/07